Define a sloped edge to a sketch line.
Revit join two gable roof at different height.
Using shape editing tools.
This video demonstrates the following.
Change the slope angle of the roof.
Select the roof and choose between raft cut and two cut in roof properties under rafter cut parameter.
After creating a roof you can adjust the height of the eaves.
The only work around i was able to come up with was draw two different roofs but i m wondering if there s anything i m just missing in the roof edit properties.
This video was recorded using revit 2012.
Then follow these 2 steps.
While in sketch mode select a slope defining boundary line.
If you use two cut you have to set a fascia height like illustrated below.
Use it to extend the dormer roof to the main roof.
Use sloped edges or a slope arrow on a roof to create sloped roof elements.
Then draw the arrow to define the slope direction.
Thx the only way to have an off centered peak with the same slope on both sides is to have one eave higher than the other.
The roof with the lower eave height would require a roof slope pitch greater that the roof with the higher eave height.
Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube.
Use join unjoin roof tool.
Use a slope arrow to define the slope.
For creating complex roof it might be easier if you create separate roof then use join roof tool to join them later.
You can use height or slope value specify the method and the constraint values from properties palette.
Click finish edit mode.
On the properties palette specify a value for offset from roof base or plate offset from base.
When using a newer software release you may notice.
You like these direct simple and to the point revit tips.
9 join roofs add opening to create dormer.
To create a dormer model required walls and additional roof.
To keep the ridge line centered on the structure and have 2 eaves at different heights with identical overhangs you would have to have 2 different roof slopes.
This tool is located in the modify tab.
