Blocking diode in a solar panel is used to prevent the batteries from draining or discharging back through the pv cells inside the solar panel as they acts as load in night or in case of fully covered sky by clouds etc.
Reverse current flow in solar panels.
Thus this allows us to effectively provide solar battery charging with reverse current protection.
It is often recommended that a diode be fitted to prevent reverse current flow back through a pv solar panel at night time dark current as current passes through a diode there is a voltage drop with power lost as heat.
In some circumstances these electrical faults in solar panels lead to current being forced in the wrong direction through a string of pv modules.
In short as diode only passes current in one direction so the current from solar panels flows forward biased to the battery and blocks from the battery to the solar panel.
The internal diode structure of the solar cells causes reverse current to flow through the faulty generator string that depending on the strength of the current may lead to excessive heating or destruction of the modules in this string.
Some solar panels are actually two or more panels wired in parallel inside a common frame.
However in the dark when no voltage is being produced by the panels the voltage of the battery would cause a current to flow in the opposite direction through the panels discharging the battery if it was not for the blocking diode in the circuit.
Blocking diodes will be of benefit in any system using solar panels to charge a battery.
It s also reversing the political power in the system enabling customers to evade most utility strategies for curtailing competition.
Many older books and articles recommend using blocking diodes to prevent reverse current flow back through the panel at night dark current many others do not including us mostly.
Diodes are components which allow current to flow in just one direction.
With a small 6v solar panel the losses in the diode would exceed the power which would have been lost.
The combination of distributed energy storage and distributed solar is reversing the power flow allowing customers and communities to generate most of their energy at home or nearby.
Also we use a charge control circuit designed to stop reverse current flow and charge the battery effectively using the solar panel.
In the junction box are bypass diodes so that if one or more of the cells on the panel become shaded the full current of the rest of the enlightened panel will not be applied to the reverse biased shaded cells.
Depending on the source of the power this reverse flow may be intentional or unintentional.
If not prevented in the case of unintentional backfeeding or properly installed in cases of intentional backfeeding backfeeding may present unanticipated hazards to electrical.
Solar panels reverse current issues green power operate a dedicated solar service and maintenance division which often finds electrical faults in pv systems.
