Slide and snap the pieces of siding onto the courses below and replace the nails you removed.
Replace overlapped siding at lower pieces.
You may want to drive the nails in new locations to ensure that they have good purchase.
How to change a piece of broken wood siding.
Slide the vinyl siding removal tool just under the bottom lip of the uppermost piece of vinyl siding and pry gently upwards.
Replace siding by working from the bottom up you might need a helper here.
Now the process is fairly simple.
You can use a tape measure to mark the reveal of each piece of replacement siding or make a spacer gauge from two blocks of wood screwed together.
Fiber cement siding is resistant to this type of decay and is available in the same dimensions and patterns as the hardboard products so you don t have to replace all the siding on the house just the pieces that are damaged.
When it s time to put the siding back on the wall just reverse the process.
Wedge the board away from the house by driving wedges up under the damaged board to pull it out from the sheathing below.
Vinyl siding is installed from the bottom up so you must loosen it in the opposite direction.
Repeat steps 3 5 for any additional courses of siding that you need to remove.
Subscribe to this old house.
The courses should overlap by at least 1 in.
Reconnect all of the interlocking pieces using the siding tool to help you.
Above the bottom edge.
Attach the siding with 10d galvanized box nails driven into the overlap at least 1 2 in.
Wood rot woodpecker beaks and hailstorm damage are common reasons.
Wooden lap siding lasts for many years but occasionally a piece sustains damage.
J piece that locks into place with the lip on the lower piece.
Here s how to repair damaged clapboards also known as bevel or lap siding.
To remove replace an entire wall of siding.
To install the replacement siding start at the bottom and work your way up.
Now we replaced the siding with a different type of siding called fiber cement.
Ask this old house general contractor tom silva helps a homeowner repair sections of his vinyl siding that have holes.
Once the snap seal releases use gloved fingers to loosen the siding to a distance of 3 feet from the corner.
