Remove Kohler Bathroom Faucet Cartridge

Loosen the screw underneath the plug button to remove the handle fig.

Remove kohler bathroom faucet cartridge.

Remove the plug button from the handle fig. Replace all rings with the matching size. Leaking under the handle. Install a hose in a pull out sprayhead kitchen faucet.

The water supply valves are typically located underneath the faucet. Most bathroom faucets that have two handles are cartridge style faucets. Rotate the handle to the right to cut the supply. Using your other hand turn the skirt the decorative flared piece below the handle counterclockwise.

Once you have removed the screw you will have access to the bonnet on your kohler faucet. With the cartridge out inspect o rings for any damage. Floor mount bath filler diverter removal. The bonnet should remove easily by hand fig.

Unscrew the bonnet counterclockwise to expose the valve and the mounting nut. On some models of faucet you may have to remove the cartridge with a specialized tool which will be indicated on manufacturer s instructions. To remove the handles for the forte widespread bathroom or bidet faucet refer to the following directions. Turn off the water to the faucet.

Cover the drain with tape to avoid the loss of any small parts. To remove it use a glove with grips or a jar remover to turn the piece counterclockwise. Turn off the water supply for the kohler faucet in which you want to change the cartridge. On most two handled faucets this can be done by unscrewing the bonnet under the lever.

Change a kohler ceramic valve cartridge from hot to cold components floor mount bath filler. Hold the handle with one hand. See all 35 articles repair. A step by step interactive guide is also available to help you remove your kohler valve trim identifying and removing single control shower valve trim.

The instructions still apply. Once it has been removed set the bonnet aside so you can proceed with repairs to the o ring or cartridge. The images below that show how to remove the valve trim may not look like exactly like your trim. Each faucet handle hot and cold has its own cartridge a valve that turns with the handle to control the flow of water into the faucet spout.

If you have a very old two handle faucet it may be a compression type rather than a cartridge. This will enable you to screw it off the top of the faucet. On knob style faucets a plug button covers the screw to remove the handle. With the handle removed the top of the valve will be visible fig.